2007 charger rear fold down seats, need
looking so see if anyone has any rear fold down steats that will work for my 2007 charger. mine came with hardbacks and i dont have thaT OPTION to fold down the seats. thanks
View ArticleA pillar dual guage pod?
What do you guys use for an a pillar dual gauge pod? I see all the major vendors carry this from Razor's Edge: http://www.razorsedgemotorsports.com..._p/306-2gp.htm However that's marketed for the...
View ArticleSt.louis, mo SLAM car club. MOPAR meet and greet
Hey, I am apart of a car club in the st.louis by the name of SLAM car club. St.Louis American Muscle. We are all dedicated to enjoying our vehicles, while aiming for performance upgrades. We are MOPAR...
View Article06 srt 300 parts & other
6.1 camshaft $60 6.1 TB 60 6.1 srt exhaust OEM kicker speaker $175 2013 300 spoiler gray $80 2013 300 key fob $60 backup camera that mounts to license plate 2013 300 rear rotors and pads 2013 super bee...
View ArticleCharger Afr
So, I just finished my AFR install. I have an AEM UEGO inline AFR controller and a DiabloSport Trinity. Here are the main mods to my power plant: LMI True CAI v2 Corsa Cat-Back 2.5'' Xtreme DiabloSport...
View ArticleAIT issues
Ive been watching the AIT temp vs ambient in my 05 Magnum rt for close to a month now and the lowest ait temp ive seen is 111 when ambient was 57. I consistently run 35-40 degrees over ambient, even a...
View ArticleGetrag axles
Have the pumpkin and the hubs(pretty sure they're the same) just need the 225mm axles, let me know whT ya have.
View ArticleClik here to view.
misc question on engiine build
I was hooking up some wiring and stuff and was curious on my KB 3.6 manifold. When I set it in place I notice that the inlet and outlet water lines that run in the block valley interfere with the...
View ArticleDrop in pistons question
So I notice on arrington's they sell drop in pistons that says they are for the 5.7 and the 6.4. My question is do they actually work for the 5.7? I shot them an email last night so they might not...
View ArticleIs upgrading to getrag a must do?
I'm trying to do around 650 to the wheel so will upgrading the axels and driveshaft be enough to protect the rearend or will I need to upgrade to getrag?
View ArticleMUST SELL Trinity T-1000 Tuner $400
Works fine, just don't need the Tuner anymore. Currently married with my car, but can unmarry within minutes. PM me for more questions. I am located in California, Bay Area.
View Article419 f1a build
Let my build begin. Just received my 419 6.1 based with manley rotating assembly. 9-1 compression around .600 lift 232/243 duration 114cl. Apache heads with psi 1511 springs. And a f1a-94 procharger....
View Articlefull engine rebuild question
good evening everyone, I have to get my engine rebuilt due to low oil pressure when at operating temp and a knock/bad lifter. What I wanted to due during the rebuild is install some performance...
View Articlemagnum to low
I have a 2005 magnum r/t with the Eibach custom sport suspension system. Ever since it was installed the car didn't lower 1&1/2 inches,it lowered almost 2&1/2 inches. Has this happened to...
View ArticleBest cams for 5.7 Hemi without removing heads and is also easy to tune.
Hello all, sorry if this is a frequent question, but I'm looking for some info on what's the best cam for a 5.7 hemi (non-VVT) without pulling heads, and also easy to tune. The car is my daily so I'm...
View Article300S AWD Owner
Hello! I recently purchased a 2013 300S AWD with the Luxury Group and with 10,000 miles on it. It's black with red leather interior. My previous car was a Dodge Caliber SRT with 350+ HP, so the...
View Article300 Upgrading to 20" from 19" wheels
Hello All!! I have a 2013 300S AWD. Ordering 20 inch wheels tomorrow. I'm assuming the only way to correct the speedometer is to have the dealer do it with a Starscan.
View ArticleClik here to view.
Show your ride for Brandon 2015 Pictures
An awesome turn out today with over 600 cars attending Just a few pics from todays show
View Articlenoesp mod question
hello everyone, I just split the violet / lightblue wire and installed my own switch, works perfectly (the switching part...). Haven't tried going sideways yet (piggie decided to come into the parking...
View ArticleFan Setting help
Hello guys. I'm running a 180 T-Stat. I have a problem with choosing the best fan setting temperature I live in the Middle East where the temperature reaches 115F during the afternoon. The humidity...
View Article