Hi
Just got my new DSS aluminium 1 pieces Drive shaft installed in my SRT8 magnum and I am having a lot of clearance issue !
Anyone have same issue that can help me with their solution ?
Got Zero gap between the gaz tank heat shield on the passenger side, so I decided to shim .200" the front of the differential.
Now got a bit of clearance there
then I saw Zero gap also in the middle on top of the floor at seam joint, I shim .125" the rear of the transmission to get a bit of clearance.
I was thinking I was done with clearance issue until I installed the exhaust !
Again, the resonator was applying big pressure on the Drive shaft, Had to lower exhaust with wood block temporary to drive the car !
Even with all this, The drive shaft still hit hard the gaz tank and body under deceleration !
How Do I fix those clearance issue ?
Just got my new DSS aluminium 1 pieces Drive shaft installed in my SRT8 magnum and I am having a lot of clearance issue !
Anyone have same issue that can help me with their solution ?
Got Zero gap between the gaz tank heat shield on the passenger side, so I decided to shim .200" the front of the differential.
Now got a bit of clearance there
then I saw Zero gap also in the middle on top of the floor at seam joint, I shim .125" the rear of the transmission to get a bit of clearance.
I was thinking I was done with clearance issue until I installed the exhaust !
Again, the resonator was applying big pressure on the Drive shaft, Had to lower exhaust with wood block temporary to drive the car !
Even with all this, The drive shaft still hit hard the gaz tank and body under deceleration !
How Do I fix those clearance issue ?