Hi I have a few parts I would like to sell. Decided to go a different direction.
All parts located in Lakewood NJ, 08701
I can upload pictures after work later.
I can deliver up to 2 hours on the weekends for the cost of fuel, my truck gets 18mpg.
2007 truck block had 67,xxx miles when dissassemblied. Bored .020 over, mains have been honed and are straight, block was torque plate honed. and deck was surfaced .003 just to have a clean mating surface.
CP Bullet pistons with valve relief cuts. 9.5:1 CR
K1 forged h-beam rods with arp 2000 bolts, full floating wrist pins
K1 forged 4.050 stroker crank with reluctor wheel
Has been balanced and any added weight has been tig welded in
king bi metal bearings
new cam bearings
arp main studs and head studs included.
new melling oil pump with adjustable oil pressure via spring change.
not currently assembled, was unsure on where I was going so I have not yet gaped the rings either.
can be assembled if you prefer.
$3500 OBO
6.1 intake, was told it came off a car with 3x,xxx miles.
includes throttle body, fuel rail, and injectors.
$800 OBO
Stock 6.1 Hemi crank, needs rod journals turned but there is no deep scoring or hot spots.
$200 OBO
Misc 5.7 parts
Intake, fuel rail, injectors, front timing cover, valve covers, I have all bolts from dissassembly minus a few missing oil pan bolts, engine mounts, oil pan(some dents), oil filter housing, stock 5.7 crank needs rod journals turned.
All parts located in Lakewood NJ, 08701
I can upload pictures after work later.
I can deliver up to 2 hours on the weekends for the cost of fuel, my truck gets 18mpg.
2007 truck block had 67,xxx miles when dissassemblied. Bored .020 over, mains have been honed and are straight, block was torque plate honed. and deck was surfaced .003 just to have a clean mating surface.
CP Bullet pistons with valve relief cuts. 9.5:1 CR
K1 forged h-beam rods with arp 2000 bolts, full floating wrist pins
K1 forged 4.050 stroker crank with reluctor wheel
Has been balanced and any added weight has been tig welded in
king bi metal bearings
new cam bearings
arp main studs and head studs included.
new melling oil pump with adjustable oil pressure via spring change.
not currently assembled, was unsure on where I was going so I have not yet gaped the rings either.
can be assembled if you prefer.
$3500 OBO
6.1 intake, was told it came off a car with 3x,xxx miles.
includes throttle body, fuel rail, and injectors.
$800 OBO
Stock 6.1 Hemi crank, needs rod journals turned but there is no deep scoring or hot spots.
$200 OBO
Misc 5.7 parts
Intake, fuel rail, injectors, front timing cover, valve covers, I have all bolts from dissassembly minus a few missing oil pan bolts, engine mounts, oil pan(some dents), oil filter housing, stock 5.7 crank needs rod journals turned.